KU Instrumentation Design Laboratory

Project Examples
Up IDL Description IDL Personnel Project Examples

 


IDL Links

[Home]
[Neutrino Observatory]
[Sample Control System]
[Hardware Surface Veto]
[Mobile EFS Lab]
[Projects/MPS_Block.gif]
[MicroPotentiostat]
[Mini HV Supply]
[Guided Ion Beam]
[Servosphere]
[Q-Tools]
[pScope & pScan]


 

A few project examples are shown:
  1. The AURA Askar'yan Observatory at the South Pole.
     
  2. Sample Control System:  a Spin Speed, Power Supply, Actuator and rf Switch control system for multi-sample NMR.
     
  3. Hardware Surface Veto Board.
     
  4. Flash Photolysis and Scanning LIF System
     
  5. BiColor Leaf Photometer
     
  6. UniBlitz Shutter Controller/Programmable Sequencer
     
  7. Guided Ion Beam Instrument

  8. Entomology Servosphere

  9. MEFS Lab--An array of USB-connected electronics tools to create a full electronics laboratory for the teaching of electronics for scientists.

  10. Mini High-Voltage Power Supply

  11. Fruit fly Inebri-Actometer -- This device is used to monitor activity of 128 fruit flies simultaneously for alcoholism studies.

  12. Multi-channel, wide frequency range filter system.  A 16-channel 5-pole low-pass filter with cut-off frequency that can be programmed from less than 1 Hz to over 10 KHz.

  13. Miniature floating potentiostat.  This potentiostat is isolated from all other electrical systems.  Including the 12-bit ADC, 12-bit DAC, programmable gain amplifier, and current amplifiers, and power control systems, it occupies only a few
     cubic inches.

  14. Q-Tools--A set of software tools for enhancing the operation of QE-series NMR instruments, prepared in collaboration with the KU NMR lab.